Shopping cart
×
TIPS A
TRICKS
FitStream has been designed
to be very easy to use.
Watch our tip videos and enjoy your drinks fresh wherever you are.
START WITH LIQUID
Cut the ingredients into small pieces (about 1,5 cm pieces) to achieve a perfect result. Always start by adding liquid (such as water, milk or juice). This will make blending easier. Once the liquid has been poured, add the ingredients to the rest of the drink up to 60% of the bottle volume, close the bottle, press the button and blend.
START WITH MAXIMUM POWER
For maximum performance, you can run the FitStream upside down and allow the blades to reach their full speed before blending. Your favourite drink will be ready in seconds
Blade jamming
If the blades are stuck, simply turn the blender upside down, give it a quick shake and switch it on. Then turn it back on so your ingredients hit all 6 blades at full speed.
Do not overfill
Never fill the FitStream to the top of the jar with ingredients. It's not Superman 🙂
EASY CLEANING
Cleaning is simple. Just pour water, add a drop of detergent, start it, and rinse. During external rinsing with water, always cover the charging port with your finger to prevent water from entering.
Not dishwasher safe
Never put the blender in the dishwasher, but clean as instructed
Continuous red flashing light
When the FitStream needs to be charged, the light turns red. Charge the blender via the included USB cable with any mobile phone charger and the light will turn blue when fully charged.
Safe charging
Follow these instructions to reduce the risk of fire, electric shock, and damage. Place the device on a dry, flat, waterproof, heat-resistant, and non-flammable surface during charging. Never charge the blender after cleaning if the rechargeable USB connector is wet. Do not use a damaged electrical outlet to charge the device. If the blender does not charge within 2 hours, stop charging and contact us for a warranty claim.
Blue flashing light
Let the blender rest before further blending cycles.
Red and blue flashing light
A red and blue flashing light indicates that the container is not aligned with the base. To correct this problem, screw the container clockwise into the base until the arrow on the container aligns with the arrow on the base. For safety reasons, there are magnets on the jar that must be aligned or the blades will not spin.
Do not run on empty
Do not run the FitStream on empty to avoid damaging the blender motor. Always blend the contents with liquid.
Magnetic safety lock
For safety reasons, there are magnets on the cup that must be aligned or the blades will not spin. This protects the user from injury and is also an indicator of a properly tightened bottle from which nothing will spill.
Do not mix with open bottle
It is dangerous to mix with an open bottle or to put anything into it while mixing. Caution! Injury may occur.
Hot liquids
Do not pour hot liquids above 40°C into the FitStream as you could damage the device.
ICE CRUMB
The FitStream is also powerful enough to make ice cubes. Just add a little water and it can handle the ice challenge with ease. 🙂